Telit Wireless Solutions LE910C series - AT#ETHEN - Enable;Disable ETH

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1099 of 1904 2022-03-04
Not Subject to NDA
3.15.6. AT#ETHEN - Enable/Disable ETH
This command is used to enable/disable Ethernet MAC and PHY
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#ETHEN=<mode>[,<cid>]
Set command enable/disable ETH.
Parameters:
Name
Type
Default
Description
<mode>
integer
0
status mode
Values:
0
:
Disable ETH
1
:
Enable ETH
2
:
Auto enable
<cid>
integer
-
(PDP Context Identifier) numeric parameter
which specifies a particular PDP context
definition (see +CGDCONT command)
In case of enabling ETH with no network (No SIM card, +CFUN=4,
...), this command will return ERROR.
If target PDP is not connected to WWAN by this command, this
command will return ERROR.
If a PDP context is already established, return OK.