Telit Wireless Solutions LE910C series - AT#BCONINTMAX - BLE Maximum Connection Interval

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1868 of 1904 2022-03-04
Not Subject to NDA
3.35.18. AT#BCONINTMAX - BLE Maximum Connection Interval
This command is used to configure the BLE maximum connection interval.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BCONINTMAX=<Maximum Connection Interval>
Set command is used to configure the maximum connection interval for a
Bluetooth Low Energy connection.
Parameter:
Name
Type
Default
Description
<Maximum
Connection
Interval>
integer
N/A
It specifies the maximum
connection interval for a Bluetooth
Low Energy connection in
milliseconds.
Value:
8÷4000
:
The supported parameter value range.
This value can be saved into profile
through AT#W command.
AT#BCONINTMAX?
Read command is used to get the status of the maximum connection
interval:
#BCONINTMAX: <Maximum Connection Interval>
Where,
<Maximum Connection Interval> - Specifies the maximum connection
interval. For example:
AT#BCONINTMAX?
#BCONINTMAX: 400