Telit Wireless Solutions LE910C series - Easy Scan; AT#CSURV - Network Survey

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1463 of 1904 2022-03-04
Not Subject to NDA
Easy Scan
3.22.1. AT#CSURV - Network Survey
The command allows to perform a network survey through band channels.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
Yes
-
2
AT#CSURV[= [<s>,<e>]]
Execution command allows to perform a quick survey through channels
belonging to the band selected by last #BND command issue, starting
from channel <s> to channel <e>. Issuing AT#CSURV<CR>, a full band
scan is performed.
After issuing the command the device responds with the string:
Network survey started...
After a while, a list of network survey information text lines, one for each
received BCCH-carrier, is reported.
The format of the ending string depends on the last #CSURVF setting.
If AT#CSURVF=0 or 1 the message body ends with the string:
Network survey ended
If AT#CSURVF=2 the message body ends with the string:
Network survey ended (Carrier: <NoARFCN> BCCh: <NoBCCh>)
where:
<NoARFCN> is the number of scanned frequencies
<NoBCCH> is the number of found BCCh
The network survey information text lines parameters are described in the
Additional info sections.
Parameters: