3.22.6. AT#CSURVC - Network Survey (Numeric Format)
This command allows to perform a network survey through band channels with output in
numeric format.
AT#CSURVC[=[<s>,<e>]]
Execution command allows to perform a quick survey through channels belonging
to the band selected by last #BND command issue, starting from channel <s> to
channel <e>. Issuing AT#CSURVC<CR>, a full band scan is performed.
After issuing the command the device responds with the string:
Network survey started...
After a while, a list of network survey information text lines, one for each received
BCCH-carrier, is reported.
The format of the ending string depends on the last #CSURVF setting.
If AT#CSURVF=0 or 1 the message body ends with the string:
Network survey ended
If AT#CSURVF=2 the message body ends with the string:
Network survey ended (Carrier: <NoARFCN> BCCh: <NoBCCh>)
where:
<NoARFCN> is the number of scanned frequencies
<NoBCCH> is the number of found BCCh
The network survey information text lines parameters are described in the
Additional info sections.
Parameters:
To Next Page
Loading...
Need help?
General
