LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1537 of 1904 2022-03-04
3.23.7. AT#TCPATRUND - TCP AT Run in Dial (Client) Mode
The command enables/disables the TCPATRUN service in client mode.
AT#TCPATRUND=<mod>
Set command enables/disables the TCPATRUN service in client mode.
When this service is enabled, the module tries to open a connection to the
Host (the Host is specified in #TCPATRUNCFG).
Parameter:
to start automatically the service when the module is powered-on,
the automatic PDP context activation has to be set (see
AT#SGACTCFG command).
if the connection closes or at boot, if service is enabled and context
is active, the module will try to reconnect for the number of
attempts specified in AT#TCPATRUNCFG; also the delay between
one attempt and the other will be the one specified in
AT#TCPATRUNCFG.
while the TCP Run AT service executes a command that takes long
time to get the response, a new command will be pending until the
module has finished sending all of its response result code.
To Next Page
Loading...
Need help?
General
