Telit Wireless Solutions LE910C series - AT#USBZLPDIS - Configure Modem Ports for a Host Not Sending ZLP

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1102 of 1904 2022-03-04
Not Subject to NDA
3.15.7. AT#USBZLPDIS - Configure Modem Ports for a host not sending ZLP
This command makes USB Modem ports and SAP port available with a host not sending
ZLP packet.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#USBZLPDIS=<mode>
Set command configures Modem ports and SAP port for a host not
sending ZLP
Parameter:
Name
Type
Default
Description
<mode>
integer
0
USB ZLP
configuration
Values:
0
:
Disable; This mode is used that Host should send ZLP
after transferring a packet with maximum
size(wMaxPacketSize).
1
:
Enable; This mode is used when the host does not
send ZLP after transferring a packet with maximum
size(wMaxPacketSize).
This command could make downgrade on throughput.
This command effects to two Modem ports and one SAP port.
Manual reboot is required after changing.
The setting is maintained even after firmware updates.