Telit Wireless Solutions LE910C series - AT$GPSSLSR - Start Location Service Request

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1676 of 1904 2022-03-04
Not Subject to NDA
3.28.1.9. AT$GPSSLSR - Start Location Service Request
Command used to start the Receiver in Autonomous or A-GPS mode.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT$GPSSLSR=<transport_protocol>[,<pos_mode>[,<client_id>,<clientid_type>[,<ml
c_number>,<mlcnumber_type>[,<interval>[,<service_type_id>[,<pseudonym_indica
tor>]]]]]]
Execution command configures location service request.
Parameters:
Name
Type
Default
Description
<transport_protocol>
integer
2
Configure transport
protocol.
If <pos_mode> is
Autonomous the
<transport_protocol>
should be invalid.
If
<transport_protocol>
is C-plane and
<pos_mode> is Pure
MS Assisted, then
<interval> should be 0
(or omitted).
Values:
0
:
CPlane
1
:
SUPL
2
:
Invalid