Telit Wireless Solutions LE910C series - AT+CMEE - Report Mobile Equipment Error

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 174 of 1904 2022-03-04
Not Subject to NDA
3.2.2.41. AT+CMEE - Report Mobile Equipment Error
The command enables the use of result code.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT+CMEE=[<n>]
Set command disables/enables the use of result code:
+CME ERROR: <err>
as an indication of an error relating to the +Cxxx command issued.
When enabled, device related errors cause the +CME ERROR: <err> final
result code instead of the default ERROR final result code. ERROR is
returned normally when the error message is related to syntax, invalid
parameters or DTE functionality.
Parameter:
Name
Type
Default
Description
<n>
integer
0
enable flag
Values:
0
:
disable
1
:
enable and use numeric<err> values
2
:
enable and use verbose <err> values
The detailed description of <err> is available in section "ME Error
Result Code - +CME ERROR: <err>".