Telit Wireless Solutions LE910C series - AT#ESIMGETADDR - Configures the Default SM-DP+ Address

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 911 of 1904 2022-03-04
Not Subject to NDA
3.10.25. AT#ESIMGETADDR - Configures the default SM-DP+ address
This command configures the default SM-DP+ address on the eUICC.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT#ESIMGETADDR=<slot>[,<default_smdp_addr>]
Set command configures the default SM-DP+ address on the eUICC.
Parameters:
Name
Type
Default
Description
<slot>
integer
N/A
Slot information
Values:
1
:
slot 1
2
:
slot 2
<default_smdp_addr>
string
-
Support 0 ~ 255 character
string. Indicates the address
that must be configured on
the eUICC as the default SM-
DP+ address.
Additional info:
If <default_smdp_addr> is set to 0, the command removes the
default SM-DP+ address from the eUICC.
If the default SM-DP+ address is missing, the command retrieves
the default SM-DS address configured on the eUICC. It can also
return the default SM-DP+ address if it is configured on the eUICC.
Response: