Telit Wireless Solutions LE910C series - ATA - Answer Incoming Call

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 344 of 1904 2022-03-04
Not Subject to NDA
3.2.5.8. ATA - Answer Incoming call
The command is used to answer to an incoming call if automatic answer is disabled.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
ATA
Execution command informs the DCE that answer sequence must be
started if automatic answer is disabled.
This command must be the last in the command line and must be
followed immediately by a <CR> character.
Data only products do not start the call and command answer
is ERROR if a voice call is requested.