Telit Wireless Solutions LE910C series - AT#SGACTCFGEXT - Extended PDP Context Configuration

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1219 of 1904 2022-03-04
Not Subject to NDA
3.17.3. AT#SGACTCFGEXT - Extended PDP Context Configuration
This command manages the extended configuration of context activation.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#SGACTCFGEXT=<cid>,<abortAttemptEnable>[,<unused>[,<unused>[,<unused>
]]]
Set command is used to enable new features related to context activation.
Parameters:
Name
Type
Default
Description
<cid>
integer
N/A
PDP context identifier (see
+CGDCONT command)
numeric parameter which
specifies a particular PDP
context definition
The value of max is returned
by the Test command
Value:
1÷max
:
supported range
<abortAttemptEnable>
integer
N/A
enables/disables abort
during context activation
attempt
Values:
0
:
old behavior: no abort possible while
attempting context activation
1
:
abort during context activation attempt
is possible by sending a byte on the
serial port