Telit Wireless Solutions LE910C series - AT#BNAME - BLE Device Name

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1858 of 1904 2022-03-04
Not Subject to NDA
3.35.13. AT#BNAME - BLE Device Name
This command is used to modify the BLE local device name.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BNAME=<Local Device Name>
Set command is used to modify the local device name that is seen on a
remote Bluetooth device during device or service discovery.
Parameter:
Name
Type
Default
Description
<Local
Device
Name>
string
-
It specifies the name of the local Device
which has a limit up to 20 characters. This
value can be saved into profile through
AT#W command.
AT#BI=1 command and AT#BADVE=3 should be issued first. After
setting the local device name, enable advertising using
AT#BADVE=1
To view the device name in BLE Master scan results, the Device
Name parameter should be set to value 1 in #BADVDATA
command.
AT#BNAME?
Read command returns the values of parameters in the format:
#BNAME: <Local Device Name>
For Example:
AT#BNAME?