Telit Wireless Solutions LE910C series - AT#BCONINTMIN - BLE Minimum Connection Interval

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1870 of 1904 2022-03-04
Not Subject to NDA
3.35.19. AT#BCONINTMIN - BLE Minimum Connection Interval
This command is used to configure the BLE minimum connection interval.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BCONINTMIN=<Minimum Connection Interval>
Set command is used to configure the minimum connection interval for a
Bluetooth Low Energy connection.
Parameter:
Name
Type
Default
Description
<Minimum
Connection
Interval>
integer
N/A
It specifies the minimum
connection interval for a Bluetooth
Low Energy connection in
milliseconds.
Value:
8÷4000
:
The supported parameter value range.
This value can be saved into profile
through AT#W command.
AT#BCONINTMIN?
Read command is used to get the status of the minimum connection
interval:
#BCONINTMIN: <Minimum Connection Interval>
Where,
<Minimum Connection Interval> - Specifies the minimum connection
interval. For example:
AT#BCONINTMIN?
#BCONINTMIN: 400