Telit Wireless Solutions LE910C series - AT+IPR - UART DCE Interface Data Rate Speed

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 297 of 1904 2022-03-04
Not Subject to NDA
3.2.4.10. AT+IPR - UART DCE Interface Data Rate Speed
The command sets the speed of the DTE serial port.
[1] Hardware User's Guide of the used module
[2] ITU-T Recommendation V25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT+IPR=<rate>,<rate>
Set command specifies the DTE speed at which the device accepts commands
during command mode operations; it may be used to fix the DTE-DCE interface
speed.
Parameters:
Name
Type
Default
Description
<rate>
integer
115200
speed of the first UART serial port expressed
in bit per second
Values:
300
:
bps
600
:
bps
1200
:
bps
2400
:
bps
4800
:
bps
9600
:
bps
19200
:
bps
38400
:
bps