Telit Wireless Solutions LE910C series - AT+CMER - Mobile Equipment Event Reporting

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 154 of 1904 2022-03-04
Not Subject to NDA
3.2.2.31. AT+CMER - Mobile Equipment Event Reporting
This command configures sending of unsolicited result codes from TA to TE.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT+CMER=[<mode>[,<keyp>[,<disp>[,<ind>[,<bfr>]]]]]
Set command enables/disables sending of unsolicited result codes from
TA to TE in the case of indicator state changes.
Parameters:
Name
Type
Default
Description
<mode>
integer
0
controls the
processing of
unsolicited result
codes
Values:
0
:
buffer +CIEV Unsolicited Result Codes
1
:
discard +CIEV Unsolicited Result Codes when TA-TE
link is reserved (e.g. on-line data mode); otherwise
forward them directly to the TE
2
:
buffer +CIEV Unsolicited Result Codes in the TA when
TA-TE link is reserved (e.g. on-line data mode) and
flush them to the TE after reservation; otherwise
forward them directly to the TE
3
:
forward +CIEV Unsolicited Result Codes directly to the
TE; when TA is in on-line data mode each +CIEV URC
is stored in a buffer; once the ME goes into command