Telit Wireless Solutions LE910C series - Bluetooth Low Energy (BLE) Operations; Data Exchange: MCU to BLE Devices; LE910 Cx Peripheral to BLE Central Data Exchange

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 42 of 1904 2022-03-04
Not Subject to NDA
Numeric Format
Meaning
515
No response from network
Table 3: Message Service Failure Result Code
2.2.3. Information Responses and Result Codes
The TA response, in case of verbose response format enabled, for the previous examples
command line could be as shown below:
1. information response to +CMD1?
<CR><LF>+CMD1:2,1,10<CR><LF>
2. information response to +CMD1=?
<CR><LF>+CMD1(0-2),(0,1),(0-15)<CR><LF>
3. result code <CR><LF>OK<CR><LF>
Moreover, there are two other types of result codes:
1. result code s that inform about the progress of the TA operation (e.g. connection
establishment CONNECT)
2. result code s that indicate the occurrence of an event not directly associated with
the issuance of a command from TE (e.g. ring indication RING).
Here the basic result codes according to ITU-T V25Ter recommendation
Numeric form
Verbose form
0
OK
1
CONNECT or CONNECT <text>
2
RING
3
NO CARRIER
4
ERROR
6
NO DIALTONE
7
BUSY
8
NO ANSWER
10
CONNECT 2400
11
CONNECT 4800
12
CONNECT 9600