Telit Wireless Solutions LE910C series - AT#STUNEANT - Set Tunable Antenna Interface

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1185 of 1904 2022-03-04
Not Subject to NDA
3.15.33. AT#STUNEANT - Set Tunable Antenna Interface
This command set for Tunable Antenna Interface.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#STUNEANT=<enable>[,<band_mask>,<ant1_cfg>[,<ant2_cfg>]]
Set command for Tunable Antenna Interface.
Specific GPIO pin is available on the host interface that can be connected
to an external antenna switch.
This command can be used after setting the GPIOs from #GPIO command.
Parameters:
Name
Type
Default
Description
<enable>
integer
0
enables/disables tunable
antenna operation and all GPIOs
set.
Values:
0
:
disables (factory default)
1
:
enables
<band_mask>
hex
0x00000000
This parameter can be set when
<enable> parameter is 1.
Values:
0x00000000
:
No bands allowed
0x00000001
:
LTE BAND1
0x00000002
:
LTE BAND2
0x00000004
:
LTE BAND3