Telit Wireless Solutions LE910C series - AT#HSICEN - Enable HSIC Configuration

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1149 of 1904 2022-03-04
Not Subject to NDA
3.15.23. AT#HSICEN - Enable HSIC Configuration
This command used to configure HSIC mode as slave or master.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#HSICEN=<mode>
Set command sets HSIC configuration as HSIC master or HSIC slave
mode.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
HSIC mode
Values:
0
:
Disable HSIC configuration
1
:
Enable HSIC master mode
2
:
Enable HSIC slave mode
Manual reboot is required after changing.
The setting is maintained even after firmware updates.
If <mode>=2, USB interface doesn't work.
The default value of <mode> is 1 in LE910C1-EU/NF/LA (4G+2G).
AT#HSICEN?
Read command show current <mode> in the following format