Telit Wireless Solutions LE910C series - AT#BPNPVID - BLE Vendor ID

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1864 of 1904 2022-03-04
Not Subject to NDA
3.35.16. AT#BPNPVID - BLE Vendor ID
This command is used to set the BLE vendor ID.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BPNPVID=<Vendor ID>
Set command is used to set the vendor ID provided in the device
information service (DIS). To activate a new PNPVID value, it is necessary
to store the settings and perform a reset.
Parameter:
Name
Type
Default
Description
<Vendor
ID>
hex
By default, the
Telit vendor ID is
0x008F.
It specifies the value of vendor
ID to be set which is a 16-bit
hex value.
Value:
0x0÷0xFFFF
:
The supported parameter value range.
This value can be saved into profile
through AT#W command.
AT#BPNPVID?
Read command is used to get the status of the vendor ID in the device
information service
#BPNPVID: <PnP Vendor ID>
Where,
<PnP Vendor ID> - Specifies the Vendor ID. For example:
AT#BPNPVID?
#BPNPVID: 8F
OK