Telit Wireless Solutions LE910C series - AT#M2 MRUN - M2 M Set Run File Permission

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1633 of 1904 2022-03-04
Not Subject to NDA
3.27.6. AT#M2MRUN - M2M Set Run File Permission
This command manages the run permissions and control of the applications
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#M2MRUN=<mode>[,<file_bin>[,<delay>]]
Set command sets/resets the RUN file permission and the delay start of
the executable binary files with ".bin" extension, stored in the directory
/data/azc/mod. It supports the multi-app feature.
Parameters:
Name
Type
Default
Description
<mode>
integer
N/A
set/reset the RUN file permission
Values:
0÷2
:
Boot mode: it takes effect after next reboot, see
Additional info section, see Additional info section
3÷5
:
Immediate mode: it immediately takes effect
(start\stop), see Additional info section
<file_bin>
string
-
executable file name for which you set the
RUN file permission, its format is a
quoted or unquoted string (max 64 chars,
case sensitive). File name extension must
be .bin. If parameter is not present, the
setting is applied to all executable files.
<delay>
integer
0
is the delay parameter if the is
present, otherwise it effects all the
executables present in the
/data/azc/mod directory. Delay is relative
to AppZone engine start which is in turn
delayed by +M2M command setting.
Depending on selected two different