Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1866 of 1904 2022-03-04
Not Subject to NDA
3.35.17. AT#BPNPVSRC - BLE Source Vendor ID
This command is used to set the BLE Source vendor ID.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BPNPVSRC=<Vendor ID Source>
Set command is used to set the vendor ID source provided in the device
information service (DIS). To activate a new PNPVSRC value, it is
necessary to store the settings and perform a reset.
Parameter:
Name
Type
Default
Description
<Vendor ID
Source>
integer
N/A
It specifies the value of the vendor ID
source to be set.
The supported parameter value range is
1-2. This value can be saved into profile
through AT#W command.
Values:
1
:
Bluetooth SIG assigned company ID
2
:
USB assigned company ID
AT#BPNPVSRC?
Read command is used to get the status of the vendor ID source in the
device information service:
#BPNPVSRC: <PnP Vendor ID Source>
Where,
<PnP Vendor ID Source> - Specifies the Vendor ID source. For example:
AT#BPNPVSRC?

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English