Telit Wireless Solutions LE910C series - AT#GAUTH - PPP Data Connection Authentication Type

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 810 of 1904 2022-03-04
Not Subject to NDA
3.9.17. AT#GAUTH - PPP Data Connection Authentication Type
This command sets the authentication type used in PDP Context Activation during PPP-
PS connections.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#GAUTH=[<type>]
Set command sets the authentication type used in PDP Context Activation
during PPP-PS connections.
Parameter:
Name
Type
Default
Description
<type>
integer
3
authentication type used in PDP Context
Activation during PPP-PS connections
Values:
0
:
no authentication
1
:
PAP authentication
2
:
CHAP authentication
3
:
AUTO authentication (PAP or CHAP or no authentication
according to host application)
if the settings on the server side (the host application) of the PPP
are not compatible with the #GAUTH setting, then the PDP Context
Activation will use no authentication.
AT#GAUTH?
Read command reports the current authentication type, in the format: