Telit Wireless Solutions LE910C series - AT#BADVDATA - BLE Advertise Data

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1852 of 1904 2022-03-04
Not Subject to NDA
3.35.11. AT#BADVDATA - BLE Advertise Data
This command is used to setup the advertising data.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BADVDATA=<Include Device Name>,<Manufacturer Data>,<Service
Data>,<128-bit Service UUID>
Set command is used to setup the advertising data for a customized
advertising.
The maximum advertise data length can be 32 bytes. The AT command
parameters represent different elements in advertise data. While setting
the parameter values, make sure that the total advertise data does not
exceed 32 bytes.
Parameters:
Name
Type
Default
Description
<Include Device
Name>
integer
N/A
It specifies the device name to be
included or not in the customized
advertising data. For example, if
the value is 1, the device name will
be included.
NOTE: To display device name in
Master scan results, device name
should be included in advertise
data
Value:
0,1
:
The supported parameter value range.
<Manufacturer
Data>
string
N/A
It specifies the manufacturer
specific data to be included in the
customized advertising data.
Manufacturer specific data should
be provided as HEX string.