Telit Wireless Solutions LE910C series - AT#ENS - Enhanced Network Selection

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 464 of 1904 2022-03-04
Not Subject to NDA
3.4.33. AT#ENS - Enhanced Network Selection
Set command is used to activate the Enhanced Network Selection (ENS) functionality.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ENS=[<mode>]
Set command is used to activate the ENS functionality
Parameter:
Name
Type
Default
Description
<mode>
integer
1
ENS functionality
Values:
0
:
Disable ENS functionality
1
:
Enable ENS functionality
If AT#ENS=1 has been issued, the following values will be
automatically set and also at every next power-up:
24. All bands are enabled
25. SIM Application Toolkit enabled on user interface 0 if not
previously enabled on a different user interface (AT#STIA-2)
26. PLMN list not fixed (AT#PLMNMODE=1)
AT#ENS?
Read command reports whether the ENS functionality is currently enabled
or not, in the format:
#ENS: <mode>