Telit Wireless Solutions LE910C series - AT#LWM2 MSKIP - no Starting any Lwm2 M Client

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1588 of 1904 2022-03-04
Not Subject to NDA
3.25.10. AT#LWM2MSKIP - No Starting any LwM2M Client
The set command enables/disables the LwM2M Client startup in the module.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT#LWM2MSKIP=<enable>[,<agentMask>][,<reboot>]
The set command enables/disables the LwM2M Client initialization and
startup in the module.
It was created to give the user the possibility to control the LwM2M client
initialization.
Parameters:
Name
Type
Default
Description
<enable>
integer
0
enables or disables the "skipping
client startup" modality
Values:
0
:
skip is disabled, thus all the LwM2M clients shall
start
1
:
skip is enabled, thus all the LwM2M clients shall
not start
<agentMask>
hex
N/A
enables or disables the "skipping
client startup" modality for a LwM2M
clients set. It is expressed in
hexadecimal format.
The command admits the parameter
in hexadecimal format without the
prefix 0x.
The following values are accepted but
they will result in an ERROR as far as