LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 828 of 1904 2022-03-04
3.9.23. AT+CGEREP - Packet Domain Event Reporting
This command enables or disables the presentation of unsolicited result codes.
AT+CGEREP=[<mode>[,<bfr>]]
Set command enables/disables sending of unsolicited result codes in case
of certain events occurring in the module or in the network. The URC
formats and related events are shown in the Additional info sections.
Parameters:
controls the processing of
URCs specified with this
command.
buffer unsolicited result codes in the TA. If TA result
code buffer is full, the oldest one can be discarded. No
codes are forwarded to the TE.
discard unsolicited result codes when TA-TE link is
reserved (e.g. in on-line data mode); otherwise
forward them directly to the TE.
buffer unsolicited result codes in the TA when TA-TE
link is reserved (e.g. in on-line data mode) and flush
them to the TE when TA-TE link becomes available;
otherwise forward them directly to the TE.
To Next Page
Loading...
Need help?
General
