Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 882 of 1904 2022-03-04
Not Subject to NDA
3.10.11. AT+CGLA - Generic UICC Logical Channel Access
This command is used to control the currently selected UICC on the TE.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CGLA=<sessionId>,<length>,<command>
Set command transmits to the MT the <command> it then shall send as it
is to the selected UICC. In the same manner the UICC <response> shall be
sent back by the MT to the TA as it is. This command allows a direct control
of the currently selected UICC by a distant application on the TE. The TE
shall then take care of processing the received UICC information.
The response of the command is in the format:
+CGLA: <length>,<response>
Error case:
+CME ERROR: <err>
The response messages parameters are described in the Additional info
section.
Parameters:
Name
Type
Default
Description
<sessionId>
integer
-
the identifier of the session to be used
in order to send the APDU commands
to the UICC. It is mandatory to send
commands to the UICC when targeting

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English