Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 617 of 1904 2022-03-04
Not Subject to NDA
3.6.12. AT+CNMI - New Message Indications to Terminal Equipment
This command sets the parameters for receiving SMS messages.
3GPP TS 27.005
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT+CNMI=[<mode>[,<mt>[,<bm>[,<ds>[,<bfr>]]]]]
Set command selects the behavior of the device on how the receiving of new
messages from the network is indicated to the DTE.
Parameters:
Name
Type
Default
Description
<mode>
integer
0
unsolicited result
codes buffering option.
Values:
0
:
Buffer unsolicited result codes in the TA. If TA result
code buffer is full, indications can be buffered in some
other place or the oldest indications may be discarded
and replaced with the new received indications.
1
:
Discard indication and reject new received message
unsolicited result codes when TA-TE link is reserved,
otherwise forward them directly to the TE.
2
:
Buffer unsolicited result codes in the TA in case the
DTE is busy and flush them to the TE after reservation.
Otherwise forward them directly to the TE.
3
:
if <mt> is set to 1, it enables the hardware ring line for
1 sec.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English