Telit Wireless Solutions LE910C series - AT#V24 - V24 Output Pins Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1135 of 1904 2022-03-04
Not Subject to NDA
3.15.17. AT#V24 - V24 Output Pins Control
This command sets the state of the output pins of the AT commands serial port
interface.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#V24=<pin>[,<state>]
Set command sets the AT commands serial port interface output pins
state.
Parameters:
Name
Type
Default
Description
<pin>
integer
N/A
AT commands serial port interface
hardware pin:
Values:
0
:
DCD (Data Carrier Detect)
1
:
CTS (Clear To Send)
2
:
RI (Ring Indicator)
3
:
DSR (Data Set Ready)
4
:
DTR (Data Terminal Ready)
5
:
RTS (Request To Send)
6
:
RXD (Receive Data)
7
:
TXD (Transmit Data)
<state>
integer
N/A
State of AT commands serial port interface
output hardware pins (0,1, 2, 3, 4, 5, 6, 7)
when pins are in GPIO mode (see
AT#V24CFG):