Telit Wireless Solutions LE910C series - Page 1134

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1134 of 1904 2022-03-04
Not Subject to NDA
The default value of parameter <mode> for pin0, pin2 and pin3 is 2
in LE910C1-EU/NF/LA (4G+2G).
For LE910C1-EUX/SAX/SVX and LE910Cx-WWX product:
- Not support CTS/RTS/RXD/TXD/DTR pins
- Not support GPIO Kernel mode
- DTR pin can't be set as GPO when #M2MATP is '1'.
AT#V24CFG?
Read command returns actual mode for all the pins (either output and
input) in the format:
#V24CFG: <pin1>,<mode1>[<CR><LF><CR><LF>
#V24CFG: <pin2>,<mode2>[...]]
AT#V24CFG=?
Test command reports supported range of values for parameters
<pin>,<mode> and <save>.