Telit Wireless Solutions LE910C series - AT+CR - Service Reporting Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 97 of 1904 2022-03-04
Not Subject to NDA
3.1.16. AT+CR - Service Reporting Control
This command enables the +CR reporting.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT+CR=[<mode>]
Set command controls whether or not intermediate result code +CR is
returned from TA to TE.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
enable/disable +CR reporting
Values:
0
:
disables +CR reporting
1
:
enables +CR reporting
Unsolicited field:
Name
Type
Description
<serv>
string
The intermediate result code is transmitted at the point
during connect negotiation at which the TA has
determined which speed and quality of service will be
used, before any error control or data compression
reports are transmitted, and before the intermediate
result code CONNECT is transmitted.
Its format is: