Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1215 of 1904 2022-03-04
Not Subject to NDA
3.17.2. AT#SGACTCFG - PDP Automatic Context Activation-Reactivation
This command configures the automatic activation/reactivation of the specified PDP
context
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#SGACTCFG=<cid>,<retry>,[,<delay>[,<urcmode>]]
Set command is used to enable or disable the automatic
activation/reactivation of the context for the specified PDP context, to set
the maximum number of attempts and to set the delay between an
attempt and the next one. The context is activated automatically after
every GPRS Attach or after a NW PDP CONTEXT deactivation if at least one
IPEasy socket is configured to this context (sees AT#SCFG).
Parameters:
Name
Type
Default
Description
<cid>
integer
N/A
numeric parameter which
specifies a particular PDP context
definition
The value of max is returned by the
Test command.
Value:
1÷max
:
specifies a particular PDP context definition
<retry>
integer
0
specifies the maximum number of
context activation attempts in case
of activation failure
Values:
0
:
disable the automatic activation/reactivation of
the context
1÷15
:
supported range

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English