Telit Wireless Solutions LE910C series - Dying GASP at Commands; AT#DGEN - Dying GASP Configuration

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1825 of 1904 2022-03-04
Not Subject to NDA
Dying GASP AT Commands
3.34.1. AT#DGEN - Dying GASP Configuration
This command sets the Dying GASP configuration.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#DGEN=<mode>[,<GPIO>,<trigger>,<action>,<URC>][,<text>,<text_format>,[<SM
SNum>][,<profile_id>,<IP_protocol>,<IP_addr:PORT>]]
Set command sets the Dying GASP configuration.
Parameters:
Name
Type
Defaul
t
Description
<mode>
intege
r
0
reporting the result in the format:
#DGSTAT: <TimeStamp>,<SMSAttemptedFla
g>
Where:
<TimeStamp>: when <action> is set to 1 or 3,
the timestamp of the last time when power
loss was detected and Dying Gasp feature
was triggered.
- UTC time in seconds since Jan 06, 1980
(GPS Epoch).
<SMSAttemptedFlag> : Indicates whether
device attempted to send SMS in the last
power loss event.
0 - SMS not attempted
1 - SMS attempted
Note: This only indicates device sent the SMS
does not guarantee network delivery.