Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1069 of 1904 2022-03-04
Not Subject to NDA
3.13.5. AT#MSDSEND - Sending MSD Data to IVS
This command sends MSD data to IVS modem.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#MSDSEND
Execution command allows to send 140 bytes of MSD data to the IVS
embedded while modem is in command mode.
The device responds to the command with the prompt '>' and waits for
the MSD to send.
To complete the operation, send Ctrl-Z char (0x1A hex); to exit without
writing the message send ESC char (0x1B hex).
If data are successfully sent, then the response is OK.
If data sending fails for some reason, an error code is reported.
The maximum number of bytes to send is 140; trying to send
more data will cause the surplus to be discarded and lost.
AT#MSDSEND?
Read command reports the stored MSD data, in the format: <stored MSD
data>
AT#MSDSEND=?
Test command returns the OK result code.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English