Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1092 of 1904 2022-03-04
Not Subject to NDA
3.15.2. AT#ETHCFG - Ethernet LAN configuration
This command configures ethernet LAN parameters for gateway, subnet mask, DHCP
and DNS.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT#ETHCFG=<GWIPAdddress>,<SubNetMask>,<Start_IPaddress>,<End_IPaddres
s>[,<DNS1>[,<DNS2>]]
Set command configures ethernet LAN parameters for gateway, subnet mask,
DHCP and DNS.
Parameters:
Name
Type
Default
Description
<GWIPAdddress>
string
-
Gateway IP address.
<SubNetMask>
string
-
Subnet mask for gateway.
<Start_IPaddress>
string
-
Starting of IP range to be assigned
by DHCP server to clients.
<End_IPaddress>
string
-
Last of IP range to be assigned by
DHCP server to clients.
<DNS1>
string
-
Preferred DNS server IP address
<DNS2>
string
-
Alternate DNS server IP address
This command is used for DHCP and DNS configuration.
This command is available when ethernet is in LAN mode and ethernet is
enabled.
If LAN parameters are changed by this command, the other interfaces
(RNDIS, ECM or WLAN) will be affected.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English