Telit Wireless Solutions LE910C series - AT#CFLO - Command Flow Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 309 of 1904 2022-03-04
Not Subject to NDA
3.2.4.15. AT#CFLO - Command Flow Control
This set command enables/disables the hardware flow control in command mode.
If enabled, the flow control is applied to both data mode and command mode.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT#CFLO=<enable>
Set command enables/disables the flow control in command mode. If
enabled, the current flow control configured by +IFC, &K,\Q is applied to
both data mode and command mode.
Parameter:
Name
Type
Default
Description
<enable>
integer
0
enable/disable hardware flow control
Values:
0
:
disable flow control in command mode
1
:
enable flow control in command mode
Setting value is saved in the profile.
This behaviour is valid only for Main UART port.
In case of USB port, flow control always enabled independent of
this setting.
AT#CFLO?
Read command returns current setting value in the format: