Telit Wireless Solutions LE910C series - AT+M2 M - Enable;Disable M2 M Application Execution

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1639 of 1904 2022-03-04
Not Subject to NDA
3.27.7. AT+M2M - Enable/disable M2M Application execution
This command enable/disable the M2M Application execution start mode
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT+M2M=<mode>[,<delay>]
Set command sets the M2M Application start mode. After issuing the AT
command, the module automatically restart.
Parameters:
Name
Type
Default
Description
<mode>
integer
1
M2M application execution start mode
Values:
0
:
AppZone engine does not start at the next reboot
1
:
AppZone engine starts at the next reboot without
delay. Only apps with AT#M2MRUN=1 will start after
reboot, with their specific delay setting.
4
:
AppZone engine starts at the next reboot using the
delay set by <delay> parameter, if missing is used the
default value 10.
<delay>
integer
10
M2M application execution start time-
out expressed in seconds.
Parameter is used only if parameter is
set to 4.
Values:
0
:
no delay for AppZone engine to start
1÷60
:
delay for AppZone engine to start. During this
waiting time an AT command on the serial/USB