LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 279 of 1904 2022-03-04
3.2.3.13. ATS38 - Delay To Before Forced Hang Up
This command sets delay to before forced hang up.
ATS38=<dalay>
Set command sets the delay, in seconds, between the device's receipt of H
command (or ON-to-OFF transition of DTR) and the disconnect operation.
Parameter:
acknowledge timer in units
of seconds
the device will wait <delay> seconds for the
remote device to acknowledge all data in the
device buffer before disconnecting
the device doesn’t time-out and continues to
attempt to deliver data in the buffer until the
connection is lost or the data is delivered
<delay> parameter can be used to ensure that data in device buffer
is sent before device disconnects.
ATS38?
Read command returns the current value of S38 parameter.
The format of the numbers in output is always 3 digits, left-filled
with 0s.
To Next Page
Loading...
Need help?
General
