Telit Wireless Solutions LE910C series - AT#NOPTEXT - Notification Port Extension

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 321 of 1904 2022-03-04
Not Subject to NDA
3.2.4.21. AT#NOPTEXT - Notification Port Extension
Set notification port extension
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT#NOPTEXT=<noptext_enable>[,<port1_enable>[,<port2_enable>[,<port3_enable>
[,<port4_enable>[,<port5_enable>[,<port6_enable>[,<port7_enable>[,<port8_enable
>]]]]]]]]
Set command specified the port output notification (URC) messages
This command is extended from AT#NOPT command.
Unlike AT#NOPT, this command allow to specify a number of URC ports URC
message print out
Parameters:
Name
Type
Default
Description
<noptext_enable>
integer
0
enable #NOPTEXT
Values:
0
:
Disable #NOPTEXT command set
1
:
Enable #NOPTEXT command set
<port1_enable>
integer
N/A
enable port1 - UART 1 Port
Values:
0
:
disable URC message on port1
1
:
enable URC message on port1
<port2_enable>
integer
N/A
enable port2 - Telit USB Modem 1
Port
Values: