Telit Wireless Solutions LE910C series - AT#WLANPING - Send PING Request

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 742 of 1904 2022-03-04
Not Subject to NDA
3.8.19. AT#WLANPING - Send PING request
This command is used to send Ping Echo Request Messages and to receive the
corresponding Echo Reply on WLAN Interface.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#WLANPING=<IPaddr>[,<retryNum>[,<len>[,<timeout>[,<ttl>]]]]
Set command is used to send Ping Echo Request Messages and to receive
the corresponding Echo Reply on WLAN Interface.
Parameters:
Name
Type
Default
Description
<IPaddr>
string
-
IP address of the remote host. This
parameter can be either:
9. Any valid IP address in the
format: "xxx.xxx.xxx.xxx"
10. Any host name to be solved with
a DNS query
<retryNum>
string
4
Number of Ping Echo Requests to send
Value:
1÷64
:
The supported range of ping echo requests to
send.
<len>
integer
32
The length of Ping Echo Request
message.
Value:
32÷1640
:
The supported range of length for Ping
Echo request message.
<timeout>
integer
50
Timeout in 100 ms units, waiting a
single Echo Reply.