Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1876 of 1904 2022-03-04
Not Subject to NDA
3.35.22. AT#BSLAVELAT - BLE Slave Latency
This command is used to configure the BLE slave latency.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BSLAVELAT=<Slave Latency>
Set command is used to configure the slave latency during connection
interval in a Bluetooth Low Energy connection.
Parameter:
Name
Type
Default
Description
<Slave
Latency>
integer
The default
value 0 uses no
slave latency.
It specifies the slave latency in
the connection intervals, in a
Bluetooth Low Energy
connection.
Value:
0÷200
:
The supported parameter value range. This
value can be saved through AT#W command.
AT#BSLAVELAT?
Read command is used to get the status of the slave latency:
#BSLAVELAT: <Slave Latency>
Where,
<Slave Latency> - Specifies the slave latency.
AT#BSLAVELAT?
#BSLAVELAT: 0
OK

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English