Telit Wireless Solutions LE910C series - AT$AGPSEN - Set GNSS Capability Supporting to Module

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1693 of 1904 2022-03-04
Not Subject to NDA
3.28.1.16. AT$AGPSEN - Set GNSS capability supporting to module
This command set GNSS capability supporting to module.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT$AGPSEN=<mode>
Set command sets GPS/A-GPS/A-GLOASS capability supporting on the
module.
Parameter:
Name
Type
Default
Description
<mode>
integer
1
GNSS capability
Values:
0
:
Standalone GPS only
1
:
Full GPS capability (Standalone GPS, A-GPS)
2
:
Full GPS (Standalone GPS, A-GPS) and A-GLONASS
capability
3
:
Not support GPS
The default value depends on operator.
For Fx980, LN920 series,
- Generic: 2
- Others: 1
AT$AGPSEN?