Telit Wireless Solutions LE910C series - ATO - Return to ON-Line Mode

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 338 of 1904 2022-03-04
Not Subject to NDA
3.2.5.3. ATO - Return to ON-Line Mode
This execution command is used, during a suspended data conversation, to return in on-
line mode from command mode. If there is no suspended conversation, it returns NO
CARRIER.
ITU-T Recommendation V. 25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
ATO
After issuing ATO command, the device returns in on-line mode.
To enter again command-mode you must issue the escape
sequence, see register S2.