Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1124 of 1904 2022-03-04
Not Subject to NDA
3.15.12. AT#SLED - STAT_LED GPIO Setting
The command configures the behavior of the STAT_LED GPIO.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT#SLED=<mode>[,<onDuration>[,<offDuration>]]
Set command sets the behaviour of the STAT_LED GPIO.
Parameters:
Name
Type
Default
Description
<mode>
integer
2
defines the STAT_LED GPIO
behavior.
Values:
0
:
GPIO tied low
1
:
GPIO tied high
2
:
GPIO is handled with specific timings. See
Additional info section
3
:
GPIO is turned ON/OFF alternatively, with period
defined by the sum <onDuration> +
<offDuration>
4
:
GPIO is handled with specific timings. See
Additional info section
5
:
status led disabled
<onDuration>
integer
10
duration of period in which
STAT_LED GPIO is tied high while
<mode>=3
Value:

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English