Telit Wireless Solutions LE910C series - AT#FWAUTOSIM - Automatic Carrier Switch by SIM

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 227 of 1904 2022-03-04
Not Subject to NDA
3.2.2.67. AT#FWAUTOSIM - Automatic Carrier Switch By SIM
This command is the functionality for automatic carrier switch by SIM.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#FWAUTOSIM=<mode>
Set command sets automatic carrier switch enable mode by SIM.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
automatic carrier switch mode by SIM
Values:
0
:
Disable automatic carrier switch by SIM
1
:
Enable automatic carrier switch by SIM
2
:
Enable one-shot automatic carrier switch by SIM
If automatic carrier switch mode is enabled, the #FWSWITCH
command will return ERROR.
This AT command is available on LE910Cx-NF, LE910Cx-CN,
LE910C1-NS, LE910Cx-AP and LE910Cx-WWX. LE910C1-AP only
for Telstra config don’t support this AT command.
AT#FWAUTOSIM?
Read command reports the current stored <mode>.
#FWAUTOSIM: <mode>