Telit Wireless Solutions LE910C series - AT+IFC - DTE-Modem Local Flow Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 305 of 1904 2022-03-04
Not Subject to NDA
3.2.4.13. AT+IFC - DTE-Modem Local Flow Control
This set command selects the flow control of the serial port in both directions.
ITU-T Recommendation V25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT+IFC=<byDTE>,<byDCE>
Set command selects the flow control behavior of the serial port in both
directions: from DTE to modem (<byDTE> option) and from modem to DTE
(<byDCE>)
Parameters:
Name
Type
Default
Description
<byDTE>
integer
2
specifies the method used by the DTE to
control the flow of data received from the
device (DCE)
Values:
0
:
no flow control
2
:
flow control by RTS control line (C105, Request to
Send)
<byDCE>
integer
2
specifies the method used by the device
(DCE) to control the flow of data received
from the DTE
Values:
0
:
no flow control