Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 306 of 1904 2022-03-04
Not Subject to NDA
2
:
flow control by CTS control line (C105, Clear to Send)
The only possible commands are AT+IFC=0,0 and AT+IFC=2,2.
Hardware flow control (AT+IFC=2,2) is not active in command
mode. To active this setting in command mode, use AT#CFLO=1.
This command is equivalent to &K command.
AT+IFC?
Read command returns active flow control settings.
AT+IFC=?
Test command returns all supported values of the parameters <byDTE>
and <byDCE>.
This command has no effect on USB interface. It's only for UART interface.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English