Telit Wireless Solutions LE910C series - AT#BSCAN - BLE Scan

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1836 of 1904 2022-03-04
Not Subject to NDA
3.35.4. AT#BSCAN - BLE Scan
This command is used to scan for all the BLE devices.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BSCAN=[<Bluetooth Remote Address>]
Set command is used to discover all the BLE devices.
Parameter:
Name
Type
Default
Description
<Bluetooth
Remote
Address>
string
N/A
It specifies the scan results using
Bluetooth remote address of the
devices to be discovered.
Value:
1÷48
:
The supported parameter value range.
The scan time value is 5 seconds.
AT#BSCAN?
Read command returns the values of parameters in the format:
#BSCAN: <BDADDR>,<NAME>,<RSSI>
Where,
<BDADDR> - It specifies the Bluetooth device address of discoverable
device.
<NAME> - It specifies the Device advertise friendly name of the
discoverable device.
NOTE: The name will be displayed only if the device is advertising.
<RSSI> - It specifies the RSSI value of discoverable device.