Telit Wireless Solutions LE910C series - AT#WLANMODE - Change WLAN Mode

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 719 of 1904 2022-03-04
Not Subject to NDA
3.8.4. AT#WLANMODE - Change WLAN mode
This command is used to change the WLAN mode (AP/STA/AP+STA/AP+AP).
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#WLANMODE=[<mode>]
Set command is used to change the WLAN mode
(AP/STA/AP+STA/AP+AP).
Parameter:
Name
Type
Default
Description
<mode>
integer
N/A
Status mode
Values:
0
:
Access point mode
1
:
STA mode
2
:
AP+STA mode
3
:
AP+AP mode
If #ETHMODE is set to 1 and ethernet is activated, this command
should not be set as STA mode or AP+STA mode.
AT#WLANMODE?
Read command returns the current mode status in the format:
#WLANMODE: <mode>
Where: