Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1194 of 1904 2022-03-04
Not Subject to NDA
Mobile Broadband
3.16.1. Ethernet Control Mode (ECM)
3.16.1.1. AT#ECM - Ethernet Control Model Setup
This command sets up an Ethernet Control Model (ECM) session.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ECM=<Cid>,<Did>
This command sets up an Ethernet Control Model (ECM) session.
Parameters:
Name
Type
Default
Description
<Cid>
integer
-
context id that will be used by ECM. Refer to
test command to know the supported range
of values
<Did>
integer
-
device id, currently limited to 0 (only one
device)
Additional info:
This command only works in ECM Mode.
This command activates a context, so all necessary setup has to be
done before it (registration, APN).
If target PDP is not connected to WWAN , return ERROR

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English